dsh-auto-mode¶

⭐ 115 · ✅ active · plugin · ⬆️ +1 recently


Type	plugin	Category	Vision & multimodal
Stars	⭐ 115	Status	✅ active
Author	NanmiCoder	Updated	2026-08-17
Subcategory	👁️ Vision tools	Capabilities	coding

One-liner¶

Safe automatic permissions for DeepSeek Harness.

About¶

Coding agents need broad access to build, test, and inspect a project without stopping every few steps. But DeepSeek Harness currently leaves a sharp choice: restricted modes interrupt normal development, while Full access removes approval entirely. dsh-auto-mode adds the missing middle ground. Routine project work runs directly inside the official workspace-write sandbox, only semantic risks outside that boundary are classified using the current DSH model and the direct user's instructions, genuine ambiguity asks once, and destructive access to critical paths is denied before execution.

📦 Install¶

dsh plugin --profile web add --save-exact @nanmicoder/dsh-auto-mode@latest

🚀 Quick Start¶

dsh plugin --profile web add --save-exact @nanmicoder/dsh-auto-mode@0.1.5

📚 Learn more¶

Install

[!NOTE] > Requires an existing DeepSeek Harness installation. > [!IMPORTANT] > Plugin 0.1.6 targets DeepSeek Harness 0.1.2-alpha.2 and 0.1.2-alpha.3. Plugin 0.1.5 belongs to the older Harness 0.1.1-rc.2 line and fails to load on both tested Alpha hosts. Keep plugin 0.1.5 pinned while staying on that RC host; Alpha users should instal

Configuration

No extra endpoint or API key is needed by default. Auto uses the current Session's DSH provider and model. A trusted profile may pin a dedicated route: config: classifierProvider: deepseek-official classifierModel: deepseek-v4-flash classifierTimeoutMs: 30000 classifierMaxOutputTokens: 1024 See DESIGN.md for the complete decision order, threat model, Windows path handling, classifie